Operation Manual
Tail Blade Grip
(H0327-S)
Flanged Bearing
8x
12x3.5mm
(HC418-S)
Tail Pitch Slider 02
(H0407-S)
Spacer
8.1x
9.2x3.2mm
Tail Pitch Slider 03
(H0054-S)
Tail Pitch Slider Assembly
Tail Shaft
(H0419-S)
Thrust Bearing
5x
10x4mm
(HC435-S)
Socket Head Cap
Screw M3x8mm
(HC050-S)
Note
: Larger ID
Socket Head Cap
Screw M2x6mm
(HC004-S)
Spacer
2x
3x3mm
(H0076-S)
Socket Head Cap
Screw M2x6mm
(HC004-S)
Bearing
5x
10x4mm
(HC411-S)
Tail Pitch Slider 01
(H0409-S)
Tail Blade Grip Assembly .....x3
Bushing
(H0435-S)
Bearing
5x
10x4mm
(HC411-S)
Tail Pitch Slider Link
(H0056-S)
Tail Blade Grip
Assembly
Washer
5x
7x0.2mm
(HC449-S)
Spacer
7.5x
10x0.5mm
(H0349-S)
Tail Pitch Slider
Assembly
Tail System Assembly
Washer
Ø3xØ7x1mm
(HC181-S)
Set Screws
M4x6mm
(HC153-S)
Tail Hub
(H0418-S)
NOTE:
After the use of Loctite,
need to the check the
proper sliding off all command
Please read this user manual carefully, it contains instructions for the correct assembly of the model.
Please refer to the website www.goblin-helicopter.com for updates and other important information. Thanks you
Note:
It is a normal for the tail to feel a bit tight after initial assembly.
After 2-5 flights allowing the system to become smooth.
Bag 10B
eg: Microlube
GL261
[H0327-S]
[HC449-S]
[H0418-S]
The set screw
should align
with the hole in
the tail shaft
Page 24
Chapter 12, Tail System ( 3 Tail Blade )