Operation Manual

ASSEMBLY OF THE BALL ON THE HORN
The rods going from the servos to the swash plate must be as vertical
as possible. Not all servos are equal, so to better align them you can
choose to use the supplied spacer H0031. Figure 4 illustrates this.
INSTALLATION OF SWASHPLATE SERVOS
The linkage ball must be positioned between 17-19 mm out on the servo arm ( figure 1 ), recommended servo arm SAB
p/n [HA050/HA051]. The 120° placement of the servos inside Goblin means the arms are difficult to access. For this reason it is
advisable to ensure alignment of the servo arms (and sub trim set) before installation of the servos in the model ( figure 2 ).
Proceed with installation following the instructions below. Figure 3 shows a completed installation.
Uniball M2
5H6
(H0064-S)
Socket Head Cap Screw M2x8mm
(HC008-S)
or
Socket Head Cap Screw M2x6mm
(HC004-S) without Uniball Spacer
..... x3
Socket Head Cap Screw
M2.5x8mm
Servo 2
SERVO ASSEMBLY 1, 2, 3
Servo 1
Uniball Spacer
(H0064-S)
Socket Head Cap
Screw M2.5x12mm
(HC026-S)
..... x9
Socket Head Cap Screw
M2.5x12mm
Socket Head Cap Screw M3x6mm
(HC044-S)
Socket Head Cap
Screw M2.5x8mm
(HC020-S)
Servo 1
Servo 3
Servo Spacer
(H0075-S)
Servo 2
Servo 3
17-19mm
Bag 9
Page 16
Chapter 8, Installation Of Swashplate Servos