Operation Manual

ADDITIONAL COMPONENTS REQUIRED
*Electric Motor: 400 - 560Kv
Maximum diameter 64mm,
Maximum height 72mm,
Pinion shaft diameter 6/8mm
*Speed controller: minimum 120A , suggest 160A
*Batteries: 12S-5000 mAh
*1 flybarless 3 axis control unit
*Radio power system, if not integrated with the ESC
*3 cyclic servos
*1 tail rotor servo
*6 channel radio control system on 2.4 GHz
(See configuration examples on page 17)
The assembly process is described in the following chapters.
Each chapter provides you with the box, bag and/or foam
tray numbers you will need for that chapter. The information
is printed in a green box in the upper right hand corner of the
page at the beginning of every chapter.
TOOLS, LUBRICANTS, ADHESIVES
*Generic pliers
*Hexagonal driver, size 1.5,2,2.5,3,4mm
*4mm T-Wrench
*5.5mm Socket wrench (for M3 nuts)
*8mm Hex fork wrench (for M5 nuts)
*Medium threadlocker (eg. Loctite 243)
*Strong retaining compound (eg. Loctite 648)
*Spray lubricant (eg. Try-Flow Oil)
*Grease ( eg. Microlube GL261 )
*Cyanoacrylate adhesive
*Pitch Gauge (for set-up)
*Soldering equipment (for motor wiring)
Inside the main box:
Box 2: Canopy, Blade Holder.
Box 3: Boom,Carbon rod, Blades.
Box 4: Mechanical parts in 4 trays:
Tray 1: Main rotor.
Tray 2: Carbon frame and tail rotor.
Tray 3: Transmission.
Tray 4: Main structure.
Box 5: Bags, Carbon parts.
Box 6: Serial Number, Tail Blades.
Inside the main box there are:
MAIN BOX
BOX 2
Manual
BOX 4
BOX 6
BOX 3
BOX 5
Tray 1
Tray 2
Tray 3
Tray 4
Page 3
Chapter 3, Components and Box