Operation Manual

CANOPY
The Goblin Urukay canopy has a very effective locking system in order to eliminate vibrations and
optimize aerodynamics.
You must install the following to complete the canopy assembly:
· Canopy grommets (Fig 6), Canopy edge protection Fig 7 and Fig 8.
The canopy hole must be 12 to 12.5 mm in diameter. Initially is 9 mm. You can enlarge the hole
slightly to optimize the vertical position of the canopy itself.
To install the canopy:
· Insert the canopy from the front up to the area of the block shown in Fig. 9
· Join the edges.
· Insert the H0036 knobs.
Knoobs
[H0036]
TAIL BELT TENSION
*Check the proper assembly of the tail boom.
*Check that the aluminum part of the tube is against the M3 stop screw.
*Loosen the tail group by loosening the 4 M3 screws.
*Install the belt onto the pulley, taking care to respect the direction of rotation (figure 1 ).
*Rotate the tail drive several times by hand.
*Load the spring by a rotation of 270° the tensioning arm ( clockwise )
*Tension the boom until the tensioning arm is aligned with the frame.
*Tighten the 4 screws.
*Check that the tail output shaft is perpendicular to the tube. (figure 2 )
*In figure 3,4, 5 you can see the three conditions, ok, too loose and too tight.
NOTE . To disassemble the tail boom it is possible to remove the pulley H0101-S without loosening the tail unit.
Remove the locking screw and pull down.
Box 2
Page 27
Chapter 13, Installation Of The Boom, Canopy