Operation Manual

2S Battery or BEC
DE-BURR THE SIDE FRAMES
We recommend de-burring the edges of the carbon parts in areas where electrical wires run.
ESC INSTALLATION
The speed controller (ESC) is installed in the front of the helicopter.
Figure 1 shows the mounting area. Figure 2 shows the installation of the Kosmik ESC from Kontronik.
Figure 3 : Shows the wiring which connects the receiver and ESC.
If the BEC used is combined with the ESC, it is recommended to use a dual wire connection and a unit battery backup.
Use 2 zip-type to lock the Tail servo wire. ( See red arrows ).
Page 19
Chapter 10, Installation Of The ESC