Operation Manual
Center Hub
(H0410-S)
Linkage Rod
M3x50mm
(H0417-S)
Plastic Ball Link
(H0402-S)
Main Blade Grip
(H0182-S)
Bearing
10x
19x5mm
(HC422-S)
Plastic Ball Link
(H0402-S)
Right Side
Left Side
eg: Microlube GL261
Blade Grip Arm
(H0464-S)
B
A
Spindle
(H0412-S)
Main Blade Grip Assembly ....x2
Note
: Large ID Inside
Socket Head Cap
Screw M6x10mm
(HC124-S)
Washer
6x
14 x1mm
(HC194-S)
Washer
10x
16x1mm
(HC230-S)
Thrust Bearing
10x
18x5.5mm
(HC438-S)
Center Hub Assembly
Radius Arm
(H0421-S)
Flanged Bearing
3x
7x3mm
(HC402-S)
Flanged Bearing
2.5x
6x2.5mm
(HC400-S)
Spacer Arm
(H0134-S)
Main Blade Grip
Assembly
Bearing
10x
19x5mm
(HC422-S)
Approx. 76mm
Radius Arm
Assembly ... x 2
Uniball M3
(H0063-S)
Swashplate
Assemly
(H0420-S)
Uniball M3
(H0065-S)
Linkage Rod A Assembly . . . .x3
DETAIL A
Socket Head Cap
Screw M3x16mm
(HC068-S)
Pin 5 mm
(H0413-S)
Socket Head Cap
Screw M2.5x6mm
(HC018-S)
Damper
Derlin
(H0486-B)
Uniball M3
(H0065-S)
Socket Head Cap
Screw M4x10mm
(HC102-S)
[HC230-S] [HC232-S]
Socket Head Cap
Screw M2.5x10mm
(HC022-S)
Spacer Arm
(H0416-S)
Flanged Bearing
2.5x
6x2.5mm
(HC400-S)
Radius Arm
Assembly
Swashplate Assemly
Uniball Radius Arm
(H0415-S)
Socket Head Cap
Screw M2.5x10mm
(HC022-S)
Socket Head Cap
Screw M3x16mm
(HC068-S)
Radius Arm
Assembly
Socket Head Cap
Screw M3x10mm
(HC056-S)
Washer
3x
4x0.5mm
(HC176-S)
[HC176-S]
Note:
The HPS3 head should be assembled with one, 1mm shim (HC230) and one, 0.2 shim
(HC232) on each side. The blade grips must move freely, but they should not move
just under their own weight. If the blade grips are too tight, you can remove the
0.2mm shim (HC232) from each side. After approximately 10/20 flights, please check
preload, you can add one or two 0.2mm shim (HC232) if preload has changed.
Bag 7
(Initial length for the rods from the
swashplate to the Blade Grip.)
* Clock-wise, counter clock-wise thread
* By turning the linkages you can adjust
tracking. If tracking is adjusted correctly,
you’ll see the metal part line up around
in the center of the opening.
Soft Oring
(HA024)
Hard Oring
(HA038)
[HA038] [HA024]
Page 13
Chapter 6, Main Rotor HPS3