Operation Manual

66mm
Approx.
54.5mm
Left Thread Right Thread
The wire for the front servo must be positioned here.
If it is necessary to tighten the
horn screw, use the included
hexagonal wrench (HA002).
Tool HA002
Linkage Rod B
Assembly
Linkage Rod A
Assembly
(Initial length for the rods from the
servos to the swash plate.)
(Initial length for the rods from the swash plate
to the Blade Grip.)
Plastic Ball Link
(H0066-S)
Set Screw M2.5x40mm
(HC242-S)
Plastic Ball Link
(H0066-S)
Approx. 63.5mm
Linkage Rod B Assembly . . . . .x3
Approx. 75mm
Linkage Rod A Assembly . . . .x2
Linkage Rod M2.5x48mm
(H0137-S)
Head Preliminary Setup
Adjust the linkage as shown.
The linkage Rod A has thread right / left.
Turning, you can change the tracking without
disconnecting the plastic ball link.
Copyright@2012 - SAB Heli Division - All rights reserved
Page 25
Chapter 12, Installation Of The Motor