Operation Manual

Socket Head Cap Screw M2.5x12mm
Tail Servo Assembly
The tail servo wire lead should be secured with hot
glue in the area indicated by the arrow (figure 1).
Figure 2 shows the installed servo.
Note: Please note that the boom edges might
be rough and can eventually chafe or cut your tail
servo lead - we recommend protecting the leads with
heat shrink or even electrical tape.
Tail Assembly
B
DETAIL B
SCALE 1 : 3.3
Servo Spacer
(H0075-S)
Carbon Rod Assembly
(HC238-S)
Socket Head Cap Screw
M2x6mm
(HC004-S)
Tail Servo Assembly
......
x4
Socket Head Cap Screw
M2.5x12mm
......
x1
Socket Head Cap Screw
M2x6mm
......
x1
Uniball M2 5H6
15-16mm
The distance between the
axis and the ball must be
between 15-16 mm
Uniball M2 5H6
(H0064-S)
Tail Servo
Copyright@2012 - SAB Heli Division - All rights reserved
Page 22
Chapter 7, Tail Servo Installation