Operation Manual

Spacer Support

Flybarless

(H0043-S)

Support

Flybarless

(H0043-S)

To install a one piece Flybarless system it is necessary to add the support shown in these figures.

Figure 4 shows the installed support. Figure 5 shows the control unit and the receiver installed on the support.

Socket Head Cap

Screw M3x6mm

(HC044-S)

Double-sided

Tape

Flybarless Unit

Flate Head Cap

Screw M3x8mm

(HC134-S)

Socket Head Cap

Screw M3x6mm

(HC044-S)

FLYBARLESS CONTROL UNIT AND RX INSTALLATION

It is possible to install any commercially available Flybarless control unit in the goblin.

For Flybarless systems with a separate sensor, the sensor must be installed under the plate (

Figure 1

Figure 2

shows an example of installation of the receiver and flybarless control unit.

Figure 3

you can see the extension lead for the tail servo. It is very important to include a connector for fast

disassembly of the boom module. The connector will prevent servo damage in case of boom separation during a crash.

Tail servo extension cable

It is important to lock the plugs of the

flybarless unit with an adhesive - for

example hot glue.

Slot for

sensor cable

Page 21

Chapter 11, Installation Of The FBL Unit and RX