Operation Manual

FLYBARLESS CONTROL UNIT AND RX INSTALLATION

It is possible to install any commercially available Flybarless control unit in the goblin.

For Flybarless systems with a separate sensor, the sensor must be installed under the plate (

Figure 3

Figure 4

shows an example of installation of the receiver and flybarless control unit.

Figure 5

you can see the extension lead for the tail servo. It is very important to include a connector for fast

disassembly of the boom module. The connector will prevent servo damage in case of boom separation during a crash.

Slot for

sensor cable

It is important to lock the plugs of the

flybarless unit with an adhesive - for

example hot glue.

Tail servo extension cable

To install a one piece Flybarless system it is necessary to add the support shown in these figures. Figure 3 shows the

installed support. Figure 4 shows the control unit and the receiver installed on the support.

Support

Flybarless

(H0043-S)

Spacer Support

Flybarless

(H0043-S)

Socket Head Cap

Screw M3x6mm

(HC044-S)

Flybarless Unit

Socket Head Cap

Screw M3x6mm

(HC044-S)

Double-sided

Tape

Figure 2-3:

Shows the installation of a 2S battery for the flight control system.

Alternatively, a BEC could be placed in the same area.

Figure 1

: Shows the wiring which connects the receiver and ESC .

If the BEC used is combined with the ESC, it is recommended to use a dual wire connection.

Page 20

Chapter 10, Installation Of The ESC