Operation Manual

DE-BURR THE SIDE FRAMES
We recommend de-burring the edges of the carbon parts in areas where electrical wires run.
ESC INSTALLATION
The speed controller (ESC) is installed in the front of the helicopter.
We recommend to use 6-8 mm connector and correct wires to support high current (>200A)
Figure 1: Shows the installation of the Kosmik ESC from Kontronik.
Figure 2 : S
hows the motor correctly wired. This drawing shows the connection between the motor and ESC using very short cables.
ESC Cables
Finishing M3
(H0007-S)
2S Battery or BEC
Flat Head Cap
Screw M2.5x5mm
(HC128-S)
ESC Support
(H0369-S)
Frame Spacer
(H0003-S)
ESC Support Assembly
ESC Support
Assembly
Socket Head Cap
Screw M3x8mm
(HC050-S)
Main Frame
Assembly
Socket Head Cap
Screw M3x10mm
(HC056-S)
Metrix Hex Nylon
Nut M3
(HC206-S)
ESC
Fig 1:
Figure 1 shows the motor correctly
wired. This drawing shows the connection
between the motor and ESC using very
short cables.
In order to install
the ESC support
module you'll have
to slightly bend the
frame doublers
(H0368) in order
for the spacers
(H0003) to reach.
This is normal
Copyright © 2013 - SAB Heli Division - All rights reserved
Page 19
Chapter 10, Installation Of The ESC