Operation Manual

Set Screw

M2.5x18mm

(HC140-S)

Plastic ball link

(H0066-S)

17.5mm

Approx.

The wire for the front servo must be positioned here.

If it is necessary to tighten the

horn screw, use the included

hexagonal wrench (HA002).

Tool HA002

Initial length for the rods from the servos to the swash plate.

Approx. 47.5mm

Plastic ball link

(H0066-S)

Initial length for the rods from the swash plate to

the blade grips.

Approx.

19.5mm

Approx. 66mm

Page 25

Chapter 12, Installation Of The Motor