Operation Manual

0.75 mm
H0287
90°
Metrix Nylon
Screw M8x14mm
(HC164-S)
Plastic Wrench Nut M8
(HA016-S)
Installation Of The Boom
- Insert the boom in place helping enlarging the frame ( Fig 1,2 ).
- Push the boom forward until the nylon bolts bottom out against the end of the slot on the boom.
- Tighten the nylon bolts and only after tighten the two M3x10mm screws.
- For additional safety, install the boom bolt safety lock (Fig 3)
Tail Belt Tension
- Make sure the boom is assembled and installed correctly.
- Loosen up the tail case by loosening the 4 M3 screws.
- Mount the tail belt on the front pulley making sure the direction of rotation is correct (Fig 4).
- Adjust the belt tension by pulling on the tail case.
- Tighten the 4 M3 screws.
- Check that the tail output shaft is perpendicular to the boom (Fig 5).
- Connect the tail push rod to the tail servo.
- Make sure the tail belt and carbon rod are free, check the belt to ensure it is not twisted.
NOTE: To remove the tail boom from the helicopter, it is possible to remove the front tail pulley
H0304-S without having to loosen up the tail case. Simply remove the locking screw and pull.
Note:
Between the boom and the aluminum plate,
there is a space of around 0.75mm.
Look the picture.
Socket Head Cap
Screw M3x10mm
(HC056-S)
Washer
3.1x 12x1.8mm
(H0078-S)
Socket Head
Cap M2.5x6
(HC018-S)
Boom Bolt
Safety lock
(H0287-S)
Bag 7.12, Bag 10.2
Page 23
Chapter 13, Boom Assembly