Operation Manual

Bearing
4x 9x2.5mm
(HC403-S)
Spacer
4x 6.9x0.5mm
(H0219-S)
Spacer
7x 9x0.5mm
(H0062-S)
Bearing
4x 9x2.5mm
(HC403-S)
Tail Shaft
(H0227-S)
Spindle Shaft
(H0220-S)
Tail Pitch Slider Link
(H0261-S)
Tail Blade Grip
H0236-S)
Oring
(HC334-S)
Tail Pitch Slider 03
(H0233-S)
Tail Rotor Hub Assembly
Note : Larger ID
Spacer
4x 6.9x0.5mm
(H0219-S)
Socket Head Cap
Screw M3x6mm
(HC044-S)
Tail Blade Grip
Assembly
Tail Rotor Hub
Assembly
Tail Pitch Slider Assembly
Socket Head Cap
Screw M2x6mm
(HC004-S)
Flanged Bearing
7x 11x3mm
(HC416-S)
Spacer
2x 3x3mm
(H0076-S)
Note : Smaller ID
Thrust Bearing
4x 9x4mm
(HC434-S)
Uniball M2.5x
5H6
(H0064-S)
Socket Head Cap
Screw M2x6mm
(HC004-S)
Tail Pitch Slider Link Assembly
Tail Pitch Slider 01
(H0233-S)
Tail Pitch Slider 02
(H0233-S)
Tail Pitch Slider
Assembly
Note:
It is a normal for the tail to feel a bit tight after initial
assembly as the tail spindle preload is ussually high when
the helicopter is brand new. The preload will loosen up
after 2-5 flights allowing the system to become smooth.
Note: S >> Left Side
Note: S >> Right Side
Tail Pitch Slider Link
Assembly
Tray 1, Bag 7.1, Bag 7.2
Page 20
Chapter 12, Tail Assembly