Operation Manual

Socket Head Cap
Screw M2x6mm
(HC004-S)
The distance between the
center of the horn and the ball
should be between 15-18 mm.
Uniball
M2
5H6
(H0064-S)
Tail Servo
Socket Head Cap
Screw M2.5x10mm
(HC022-S)
Tail Servo
Socket Head Cap
Screw M2.5x10mm
(HC022-S)
Finishing C
Washer M2.5
(H0255-S)
Canopy Positioner
(H0217-S)
Socket Head Cap
Screw M2.5x8mm
(HC020-S)
Finishing C
Washer M2.5
(H0255-S)
Tail Servo Assembly
Tail Servo
Assembly
Socket Head Cap
Screw M2.5x8mm
(HC020-S)
Tray 2, Bags 5.1, 5.2
Canopy Positioner
(H0217-S)
Finishing C
Washer M2.5
(H0255-S)
15-18mm
CF Tail Servo
Support
(H0289-S)
Tail Servo Block
(H0392-S)
Note:
Using Loctite in all 8 screws
Servo Spacer
(H0075-S)
Page 13
Chapter 7, Installation Of Servos