Operation Manual

Socket Head Cap
Screw M2.5x8mm
(HC020-S)
Spring
de 3 / df 0.53 / LL35
(HC311-S)
Metric Hex Nylon Nut M4H5
(HC212-S)
Washer
4.3x 11x1mm
(HC184-S)
Spring de 5 / df 0.3 / LL6
(HC316-S)
Finishing
Washer M2.5
(H0255-S)
Socket Head Cap
Screw M2.5x8mm
(HC020-S)
Set Screw
M4x15mm
(HC154-S)
Motor Support
(H0291-S)
Set Screw
M4x4mm
(HC152-S)
Bushing
5x 6x18mm
(H0266-S)
(Needed with 5 mm motor shaft)
20T Pulley
(H0215-20-S)
(See page 16 for additional
pulleys available)
Note:
Use this hole with
motor 30x30, M4mm.
Screw M4x6mm
(HC351-S)
5 mm
28 mm
10 mm
15°
Flat Head Cap
Screw M3x5mm
(HC132-S)
Note:
To maximize space for the batteries,
it is advisable to shorten the motor shaft.
Follow the dimensions given in this drawing.
For the cut, you can use an electric tool like a
“Dremel” with a cut-off disc.
Additionally, ensure the motor shaft has an
appropriate 'flat' for one of the set screws.
Note:
Recommended motor wiring orientation
Tray 3, Bag 3.1, Bag 3.2
Page 10
Chapter 5, Tranmission Assembly