Operation Manual
Approx 44 mm
Main Spindle
(H0508-S)
Main Blade Grip Assembly ....x2
Note
: Larger ID
Inside
Socket Head Cap Screw M6x10mm
(HC124-S)
Oring
(HC453)
Thrust Bearing
5x
10x4mm
(HC435-S)
Button Head Cap
Screw M4x6mm
(HC096-S)
* Clock-wise, counter clock-wise thread
* By turning the linkages you can adjust tracking.
If tracking is adjusted correctly, you’ll see the metal
part line up around in the center of the opening.
Center Hub Assembly
Flanged Bearing
2x
5x2.5mm
(HC456-S)
Main Blade Grip
Assembly
Bearing
10x
19x5mm
(HC411-S)
Radius Arm Assembly ... x 2
Swashplate
Assemly
(H0506-S)
Radius Plastic
Arm Assembly
Pin 5 mm
(H0413-S)
Damper
(H0518-S)
Uniball M2
(H0538-S)
Socket Head Cap
Screw M2.5x8mm
(HC020-S)
Linkage Rod A
[HC232-S]
Socket Head Cap
Screw M2.5x6mm
(HC018-S)
NOTE
: We recommend assembling without shims for sport flying.
However, for 3D flight or high RPM, the best setup is assembling
with at least one shim between the damper and bearing.
After approximately 20/30 flights, please manually check the
head dampening, you can add one 0.1mm shim (HC450) if the
dampening feels loose.
Washer
10x
16x1mm
(HC230-S)
Head HPS Assemly
Center Hub
(H0514-S)
Uniball M2
(H0537-S)
Bearing
5x
10x4mm
(HC411-S)
Main Blade Grip
(H0513-S)
Blade Grip Arm
(H0517-S)
NOTE:
Tighten with care, the arm must move freely.
Linkage Rod A Assembly .....x2
(Initial length for the rods from the
swashplate to the Blade Grip.)
Plastic Ball Link
(H0402-S)
Plastic Ball Link
(H0403-S)
Linkage Rod
M2x22mm
(H0561-S)
Right Side
Left Side
eg: Microlube GL261
Bag 4
Radius Arm
(H0516-S)
Flanged Bearing
2x
5x2.5mm
(HC456-S)
Swashplate Assemly
Uniball M2
(H0538-S)
Uniball M2
(H0538-S)
Socket Head Cap
Screw M2x10mm
(HC010-S)
Washer
7.5x
10x0.5
(H0349-S)
Plastic Ball Link
(H0403-S)
Washer
5x
7x0.1
(HC450-S)
Note:
Inside
[HC453]
[H0518]
Radius Plastic Arm Assembly ... x 2
Radius Arm
Assembly
Socket Head Cap
Screw M2x10mm
(HC010-S)
Washer
2.1x
5 x0.5mm
(HC170-S)
Radius Plastic Arm
(H0525-S)
Page 9
Chapter 6, Main Rotor Assembly