Raw 700 Manual

Page 40
CHECK LIST
9
Check Tail & Motor belt tension.
The tension has to be tight.
10
Check if the FBL-RX connectors are OK
(hot glue is recommended).
11
Check the M3 bell crank:
Belt crank movement must be smooth
and the screw locked.
( It is suggested use a bit of Green Loctite.)
Be sure the follow parts are properly
lubricated
*Main shaft/swashplate
*Tail slider/tail shaft
*Carbon rod/carbon rod support
*All thrust bearings
*All plastic balls connections
12
Check tail pulley set screws:
Ensure they are tight.
( It is suggested use a bit of Green Loctite.)
8
Check all power connectors
(Good mechanical connection).
4
7
Check the Main Linkages & Servo Linkages
Check for vertical play of the main shaft.
6
5
Check the 2 M3 screws in the Clamp.
Ensure they are tight.
1
2 3
Check main hub screws(M4 and 2 M3)
Ensure they are tight.
Tighten the main blades before flight.
Check the dampening on the main and
tail rotor to be the same as always.