Kraken 580 Nitro Manual

Thrust bearing
Damper
Head Oring
Tail Bearing
Tail Oring
Tail Bearing
Nylon Screws
Motor Belt
Tail Belt
MAINTENANCE
Take a look at the red parts.
Check them frequently. All other parts are not particularly subject to wear.
The lifespan of these components varies according to the type of flying.
On average it is recommended to check these parts every 20 flights. In some instances, based on wear, these parts should be replaced every 100 flights.
Periodically lubricate the tail slider movement and its linkages as well as the swash plate movement and its linkages.
To ensure safety you should do a general inspection of the helicopter after each flight. You should check:
- Proper belt tension (motor belt and tail belt).
- Proper isolation of the wires from the carbon and aluminum parts.
- All screws and bolts remain tight.
IMPORTANT: It is recommended to replace the 3 nylon screws after any crash, even if it is a soft crash.
Page 38
MAINTENANCE