Kraken 580 Manual

Page 39
CHECK LIST
9
Check Tail & Motor belt tension.
The tension has to be tight.
10
Check if the FBL-RX connectors are OK
(hot glue is recommended).
11
Check the M2.5x18 bell crank:
Belt crank movement must be smooth
and the screw fully tightened.
( It is suggested use a bit of Green Loctite.)
Be sure the following parts are properly
lubricated
*Main shaft/swashplate
*Tail slider/tail shaft
*Carbon rod/carbon rod support
*All thrust bearings
*All plastic ball connections
12
Check tail pulley set screws:
Ensure they are tight.
( It is suggested use a bit of Green Loctite.)
8
Check all power connectors
(Good mechanical connection).
4
7
Check the Main Linkages & Servo Linkages
Check for vertical play of the main shaft.
6
5
Check the 4 M3x10 Tail group screws.
Ensure they are tight.
1
2 3
Check main hub screws
(M4x22 and 2xM2.5x12).
Ensure they are tight.
Tighten the main blades before flight.
Check the dampening on the main and
tail rotor to be the same as always.