Kraken 580 Manual

Note: S >> Left Side
Note: S >> Right Side
Note: Smaller ID
Note: Larger ID
Spindle Shaft
(H0220-S)
Oring 90 Shore
(HC594-S)
Spacer
4x 6.9x0.5mm
(HC594-S)
Uniball
M2.5x
5H6
(H0064-S)
Socket Head Cap
Screw M2x6mm
(HC004-S)
Spacer
7x 9x0.5mm
(HC594-S)
Thrust Bearing
4x 9x4mm
(HC434-S)
Socket Head Cap
Screw M3x6mm
(HC044-S)
Tail Blade Grip Assembled
(H1233-S)
TAIL PITCH SLIDER ASSEMBLED
(H1249-S)
Tail Pitch Slider Link
(H0261-S)
Spacer
2x 3x3mm
(H0261-S)
Socket Head Cap
Screw M2x6mm
(HC004-S)
It is a normal for the tail to feel a bit tight after initial assembly as the tail spindle
preload is usually high when the helicopter is brand new.
The preload will loosen up after 5-10 flights allowing the system to become smooth.
eg: Microlube GL261
Tail Shaft Assembled
(H0227-S)
eg: Microlube GL261
Foam 2, BAG9
Shim 4.1x 5.5x0.1mm
(HC594-S)
Ball Bearing
4x 9x2.5mm
(HC403-S)
Page 15
TAIL GROUP ASSEMBLY