Goblin Fireball Manual

9-10mm
Page 15
Chapter 11, Installation of Swashplate Servos
INSTALLATION OF SWASHPLATE SERVOS
Servo Screw
(HA065-S)
Uniball
M2x
4xH3
(H0789-S)
Servo Arm
(HA065-S)
SAB Cylic Servo
included in SG281
(HE018-S)
The Cyclic servos are micro size. (SAB DS12C: Frequency 1520ms/333hz)
The linkage ball must be positioned between 9/10 mm out on the servo arm ( Figure 1 ).
It is advisable to ensure alignment of the servo arms (and sub trim set)
before installation of the servos in the model.
Proceed with installation following the instructions below.
SERVO ASSEMBLY 1, 2, 3
FRONT
SERVO SUPPORT ASSEMBLY
Socket Self Tapping
Screw M2.2 x 6mm.
(HC490-S)
Front Servo Support
(H0819-S)
Back Servo Support
[H0830]
Note: Do not over tighten,
be careful to avoid stripping
the plastic .
Socket Self Tapping
Screw M2.2 x 6mm.
(HC490-S)
Socket Self Tapping
Screw M2.2 x 6mm.
(HC490-S)
BAG 6