User's Manual

SL-TVWS-1001-User Manual and Installation Guide
Copyright Saankhya Labs Private Ltd, Bangalore
Installation of the CPE devices is identical to that of the Base station devices except for connecting the
laptop directly to the Ethernet cable. In case a WiFi router is to be used, the Ethernet cable from CPE
should be connected to the WAN port of WiFi router.
The CPE is configured to act as a router and assign IP addresses to the devices connected to it. The IP
addresses assigned by the CPE are in subnet 192.168.88.0/24. This can be changed once the CPE is
discovered through the GUI.
9) CPE Configuration
On CPE devices, it is not mandatory to program the WSDB service provider and any other device details.
User can directly proceed to connect to CPE devices
9.1 Discover CPE devices
The discovery mechanism is identical to that of the Base station. Few points to note in the process:
Figure 18 Discovering CPE devices
Notes:
1) CPE devices by default come with DHCP option enabled, hence any laptop or device connected to CPE
should be configured to work with DHCP. CPE always allocates IP address in range 192.168.88.0/24
unless it is changed by the user. This allows CPE to be connected at a well-known address
2) A CPE is also discoverable from the Base station once it is attached to the BS
On logging into CPE device, the screen should show as in Figure 19. The devices are always shipped in
installation mode, so the title bar should show that device is in installation mode