User's Manual

SL-TVWS-1001-User Manual and Installation Guide

Notes:

1) TVWS Base Station GUI application acts as proxy for all the devices connected to it. It must be kept

running all the time

2) TVWS Base Station GUI application will prompt user for frequency selection only in Installation Mode.

In Operational mode it selects the last selected frequency on subsequent interactions with the WSDB.

If this frequency is not available, it selects the first frequency available in the range of operation.

7.5 Monitoring the operation of BS device

Once the BS is in operational state, user can monitor the uplink state of the registered CPEs on the

dashboard. These parameters can be plotted in the ‘Historical Chart’ shown alongside.

7.5.1 Selecting the CPE to monitor UL parameters

Figure 15 Selecting CPE for UL parameter monitoring

7.5.2 Plotting charts for selected CPE

Follow the steps indicated in Figure 16. One or more parameters can be viewed at the same time as

shown in Figure 16. Scale is displayed for selected parameter from added group.