Installation Instructions

Push the ON/OFF button to the”On” Place.
Press the hold the Multifuction button for about 2 seconds until you hear the headset say
“Pairing” and the light flashes red and blue.
Open the Bluetooth menu on the device you wish to pair (usually located in Settings >
Bluetooth). If needed, select “search for devices”, “add new device”,or “refresh”
Select “ MEE audio BTR” and allow pairing to complete. Use “ 0000 “ if a pin is required.
Charging
Connect the Micro-USB charging cable to any powered USB port and to the charging port
of the BTR. The status indicator light will go off once the BTR is charged and ready for use.
Close the USB port completedly after charging for maximum sweat resistance.
Factory Resect
To perform a full resect, first put the BTR in standy mode (receiver is powered on but not
connected to any devices). Make sure to turn off Bluetooth or delete the “MEE audio BTR”
pairing from any nearby devices that have previously been paired with the BTR.
Once in standy mode, press and hold the Multifunction and EQ buttons simultaneously
until you hear the receiver say “Factory reset complete””Pairing”. All previously paired
devices will be cleared form memory and a new pairing will need to be created before the
BTR can be used.