Installation Guide

7. Apply caulking compound around the perime
ter of the cutout opening.
8. Attach faucet and strainers as necessary according to the manufacturer’ s
instructions.
Care and Cleaning
9. When you finsihed the cutout opening,put the silica gel around the opening, keep the gel width from 3.2-6.4mm
10. Put the sink onto cutout opening,let the sink cover the gel and make it flat
▲Use a mild detergent such as liquid dish washing soap and warm water for cleaning.
DO not use abrasive cleaners that may scratch or dull the surface.
▲Carefully read the cleaning solution on an inconspicuous area before applying to the
entire surface.
▲Do not allow cleaners to sit or soak on the surface.
▲Wipe surfaces clean and rinse completely with water immediately after cleaner
application. Rinse and dry any over-spray that lands on nearby surface.
▲Use a soft and dampened sponge or cloth .Never use an abrasive material such as a
brush or scouring pad to clean surfaces.
▲Be especially careful with colored sinks. For colored sinks; soap and water is all
you'll need to clean it in combination with a soft sponge
Tip: Sometimes sinks come with additional mounting hardware t
hat can be used if
helpful to secure it additionally