Manualshelf

Owner's manual

ManualsBrandsS&S Cycle ManualsFor motorcyclesX-Wedge Rubbermount (XW-R) Transmission Case with Engine and Swing Arm Mount
12345678
6
15- Remove the jack and slide the inner primary back on to ensure that all the bolt holes still line up.
16- If the holes do not line up then reposition the jack, loosen up the transmission bolts, and repeat steps 8 through 15.
17- Check the torque of these fasteners after the initial 50 miles and again at the rst oil change.
Thank you for choosing S&S products!
Picture 15