Owner's manual

5
12- On the cam side (right side) of the bike use a feeler gauge to check the gap between the transmission plate and the top mounting surface of
the transmission.
13- If a gap is present remove the transmission plate and insert the necessary shims on the right and left of the mounting pads of the transmission
plate and the transmission.
14- Install and tighten all four bolts to 54 ft-lbs. Use Loctite® 272™ or equivalent. Check the alignment of the primary while tightening the bolts by
sliding the inner primary on and o. There should be no binding or interference.
Picture 12
Picture 13
Picture 14