Owner's manual

3
6- Install the supplied transmission plate with the two raised bosses facing down and placed into the counter bore of the rear mounting holes of
the engine case.
7- Install the four supplied bolts, washers and nuts.
NOTES:
There are two washers for each bolt.
•
Bolts must be inserted from the bottom side due to interference with the rear cylinder. •
8- Using the jack to align the engine and transmission, carefully slip on the " engine spacer and inner primary. Do not use sealing o-rings for this
alignment check.
Do not force the primary on or allow the inner primary to support excessive weight. Any excessive force may damage the inner primary.
Picture 4
Picture 5
Picture 7
Picture 6
Picture 8
CAUTION