Software Instruction Manual

7. Match the wire colors of the relocation harness to the wires of the stock harness. Use the supplied hardware to butt splice the wires

together and insulate the connections with heat shrink.

G. Pro Tune II Software Installation

To install Pro Tune II for the rst time or to upgrade Pro Tune II, perform the following:

1. Close all applications, especially any S&S Cycle programs that are currently running.

2. Insert the Pro Tune II installation CD into your CD or DVD drive. After a few moments the Pro Tune II Software Manager should appear on

your screen and you can skip to step 5. If this doesn’t happen automatically, proceed with steps 3 and 4.

3. From the Start menu of your computer, select Run.

4. In the box marked Open: type d:\setup.exe and press Enter or click OK. Most PCs have the CD-ROM drive letter ‘d’. Replace this with the

appropriate letter if your CD drive is installed dierently.

5. The Pro Tune II Setup Wizard will appear on your screen. Select Next to continue the installation, or select Cancel to exit the installation.

Picture 5