User Manual

2



• Before doing any of the following installation, be sure to disconnect the negative cable of your battery.
• Consult an appropriate factory service manual for safety instructions on how to disconnect the fuel system from your motorcycle.
• Gasoline is extremely ammable. Please be sure to work in a well ventilated area and do not have an open ame near the work area.
• The following installation should be only done by a qualied technician with the proper tools and training. If you are not certain of
your capabilities or do not have the correct tools for this installation, S&S recommends you consult a shop to have it done for you.
Improper installation of this product could result in damage to the motorcycle and motorcycle components.
Note: You will have to transfer the following components from the stock induction module to the S&S® throttle-by-wire Throttle Hog throttle body. If this
is a new installation or custom application, these parts will need to be sourced from a certied Harley-Davidson® dealer:
 •Temperature/ManifoldAbsolutePressure(MAP)SensorH-D®PN32319-07
 •FuelRailAssembly(includingM5x.8Torxheadmountingscrew,fuelline,fuelrail,andfuelrailplate)H-D®PN61208-10andH-D®PN27721-08.
 •Dependingonthechosenaircleanerkit,theInductionModuleBracketH-D®PN27712-08with4705screwsmayberetainedaswell.S&S
recommendsusingtheSuperStock™StealthAirCleanerkitsinwhichthisbracketwouldnotbeneeded.
The following parts will also be required for the S&S throttle-by-wire Throttle Hog throttle body.
 •Screamin’Eagle®ProhighowinjectorsH-D®PN27796-08
 •IntakeManifoldFlangeH-D®PN27059-05A(2pk)(58mm&66mmOnly)
 •IntakeManifoldFlangeSealH-D®PN27035-05(2pk)(58mm&66mmOnly)
 •IntakeManifoldFlangeandSealKitS&SPN16-0250(70mmOnly)
 •Aperformancemotorcycletuningmodule.S&SrecommendsDynojet®PowerVision,orScreamin’EagleSuperTuner
Tool Requirements:







WA RNING
CAUTION
Picture 1