Owner manual

4
7- Mount the VOES switch as close to the carburetor as possible using the included bracket. Note: There is no polarity on the VOES so either wire
can be used for ground or signal.
8- Connect the VOES hose from the switch to the nipple in the manifold. Trim the hose to be as short as possible without stretching or kinking it.
NOTE: The Super Stock® ignition is a single-re design requiring a single re coil with a minimum of 3.0 ohms resistance, measured across the primary side
of the coil. (The primary side of the coil is the side where wires from the ignition will be attached). Dual-plug engines will require two coils or a four-tower
coil.
9- You will need to make some crimp connections once you trim the wires to their proper lengths. Then, to wire the system follow the wire
connection table below and Figure A to the right.
Picture 6
Picture 7
Picture 8
IGNITION MODULE
White/Black Switched 12-volt power Small ring terminal
Pink Front cylinder on coil Small ring terminal
Blue Rear cylinder on coil Small ring terminal
Violet/White VOES Tab assembly (male)
Brown Tachometer/Diagnostic Port Tab assembly (male)
VOES SWITCH
Black Ground Large ring terminal
Black Ignition module Receptacle assembly (female)