Owner manual
6
Picture 8.
Adjustable Pushrod Installation And Adjustment
NOTE: S&S® adjustable pushrods have 32 threads per inch, and 24 ats
will place the pushrod in the optimal position of the stock style tappet.
If pushrods other than S&S adjustable or quickee's are used, refer to the
manufacturer's instruction sheets to nd the number of ats needed.
If the engine is rotated before the tappets have bled down and
the pushrods can be rotated by hand, valve to valve or valve to
piston contact may occur. Serious engine damage could result.
Stock Non-Adjustable Pushrod Installation
NOTE: Using stock pushrods is only possible if the camshafts installed
have the same base circle as stock, and no more than .585" lift. S&S® labels
these cams as "Bolt-In" for easy reference. Currently S&S 510, 551 and 583
cams are bolt-in.
Picture 8
7
6
4
10
8
1
9
5
3
2
CAUTION