Manualshelf

Instruction Manual

ManualsBrandsS&S Cycle ManualsFor motorcyclesSlip-On Performance Muffler
123
3
Harley-Davidson® Softail® Shotgun 2007-Up
a. Remove old muers by working them loose with a back and forth rocking motion, then slide them o of the exhaust pipes.
b. Slide S&S muers onto exhaust pipes. Slide clamps back into place. Tighten the clamps only until snug at this time.
Softail® Shorty 2007-Up
a. Remove old muers by working them loose with a back and forth rocking motion, then slide them o of the exhaust pipes.
b. Slide S&S muers onto exhaust pipes. Slide clamps back into place. Tighten the clamps only until snug at this time.
Sportster® Motorcycle 1987-2003
a. Remove old muers by working them loose with a back and forth rocking motion, then slide them o of the exhaust pipe.
b. Slide S&S muers onto exhaust pipes. Slide clamps back into place. Tighten the clamps only until snug at this time.
Sportster® Motorcycle 2004-up
a. Remove old muers by pulling rear of each muer outwards clear of the mounting/exhaust crossover bracket, then work them loose
with a back and forth rocking motion, and then slide them o of the exhaust pipe.
b. Remove and save the existing OEM interconnect seals from between the muers and the mounting/exhaust crossover bracket.
c. Slide S&S muers onto exhaust pipes Align crossover on each muer with crossover connection of mounting bracket. Place the existing
OEM interconnect seals from step (b) on each end of the mounting/exhaust crossover bracket. See Picture 2. Push muer crossover tube
into place over interconnect seal.
5. Re-install muer to bracket mounting bolts. Tighten only until snug at this time.
6. Align muers and mounting bracket for best t. After aligning the exhaust system, securely tighten all fasteners and clamps. OEM TORCA
exhaust clamps torque to 45-60 ft. lbs. Re-install heat shields as required.
NOTES:
Loctite® 243 blue threadlock is recommended on the rst three threads of non self-locking fasteners.
•
Muer bracket to motorcycle frame bolts may be loosened to aid muer alignment, if required. •
Cleaning the outside of the muers after installation and before starting the motorcycle is recommended to keep any oil or ngerprints from burning •
onto the surface.
If replacing non-original equipment muers with S&S muers, the existing mounting brackets and fasteners may not work. Installation must use stock
•
mounting hardware and brackets.