Manual

Ignition Timing Adjustment
TO BE PERFORMED ONLY BY AN AUTHORIZED SERVICE AGENT. Ignition timing is not to be adjusted. Contact your authorized S&S® dealer
if service is required.
NOTE: Engines with Super Stock® ignition come timed from the factory and have a tamper proof seal. Breaking this seal will void the engine warranty.
Storage
If the motorcycle will be stored for several months, the carburetor oat bowl should be drained to avoid a buildup of gum or varnish. The following
procedure should be used:
1- Fully close the petcock.
2- Place small, open container below oat bowl.
3- Unscrew drain plug to allow gasoline to drain into container.
Gasoline is extremely ammable and vapors can be toxic or explosive. Adequate ventilation must be provided and sparks or open ame
avoided when working with gasoline.
4- Reinstall and tighten drain plug.
Engine Specications
Slow Idle Speed: 1050 RPM with engine warm
Ignition Timing: 20 deg BTDC @ 2,000 RPM
Idle Mixture: < 2.0% CO Warm Idle
Spark Plug: 4265 or Equivalent
Spark Plug Gap: 0.040”-0.045”
Fuel: Unleaded Gasoline Only, 91 R+M/2 Octane
Oil: Refer to Engine Oil section in this manual.
CAUTION
WARNING