Manual

2. Installation of the Knock Sensor Kit
• KnockSensormustbemountedtotherearcylinderforcorrectoperation.
• MountingtheKnockSensoronthefrontcylinderwillprovideanincorrectsignal.
NOTE: There are two mounting locations possible for the knock sensor. Read the description of each location, and then examine your motorcycle for which
one to use. The rst location has better clearance than the second location, the knock sensor will work well in either one.
Location 1: 


Location 2: 

   

    
    
    See Picture 8, below left.
   

    
    
See Picture 9, below right.
Carefully place fuel tank back into position to check Knock Sensor and mounting block clearance. Position the mounting block so that
the Knock Sensor or mounting block does not contact the fuel petcock or any other part of the motorcycle. If the wiring harness or outer
body of the Knock Sensor (black plastic portion) contacts the engine or any other part of the motorcycle, it could damage the Knock
Sensor, or interfere with its ability to detect knock. Special care for rubber mounted motors must be given to accommodate engine
movement in the chassis. View Knock Sensor while motor runs to make sure it has proper clearence.
    

6
CAUTION
Picture 8 Picture 9
CAUTION