Manual

See Picture 15 for pin locations. Do not connect any other pins except pins 1 & 2.
  
  
  




Example: After ashing the initial start sequence (as described above) there will be a pause, then ash, ash, ash, ash, (1.2 second pause) ash. (3
second pause) sequence repeats. This indicates code 41, meaning there is a problem with the crank position sensor.
NOTE: See chart for denitions of fault codes supported by the S&S® ignition module.
  
  
3. Retrieving codes using the S&S IST Guardian™ Diagnostic System (P/N 55-5075)
  

  
NOTES:
• Before purchasing the S&S IST Guardian™ Diagnostic System (P/N 55-5075) note that the software is only compatible with Windows® 2000/XP/Vista/7 32-
bit systems. It will not work on 64-bit operating systems.
• Also, be aware that the Guardian system is only compatible with the S&S IST ignition module. It will not work with stock Harley-Davidson® or other
aftermarket modules.
12
CAUTION
Picture 15
Note position of connector lock
Pin 1
Pin 2