User guide
C. Securing Motorcycle
Motorcycle must be adequately secured against falling over during the Ignition system installation! Use of tie down straps on both sides
of the motorcycle is recommended
Disconnect negative terminal of battery to eliminate potential sparks and inadvertent engagement of the starter while working on
motorcycle
D. Removal of Existing Ignition Components
1. Ignition Module
See Picture 3, below left.
See Picture 4, below right.
2. Existing Coil and VOES
E. S&S System Installation
Clearances are limited at the front of the tank. Use care not to damage any painted surfaces while handling tank.
4
Picture 3 Picture 4
CAUTION
WARNING
CAUTION