User guide
NOTE: Locking tabs on each connector listed should produce a light “click” sound when properly assembled. S&S recommends checking each connection
by lightly pulling on each half of the connector to ensure that the locking tabs have properly seated.
(f) (See Picture 13, previous page)
Table 1, below right,
See Picture 14, below left.
(g) (See Picture 13)
(h) (See Picture 13)
See Picture 15, below.
7. IST Wiring Adapter for early model and custom installation.
NOTES:
• Thissectionisonlyformotorcycleswithoutanexisting8-pinignitionconnector.
• IftheISTIgnitionwillbeinstalledonamotorcyclewithanexisting8-pinconnector,thefollowingharnessadapterinstallationinstructionsdonot
apply.
• The ISTwiring harness adapter allows installation of the IST ignition on a post shovelhead/pre-8-pin connector wiring harness (1984 to 1994
carbureted).
• Theharnessadapterisalsoforanycustombuiltcarbureted(1984-1999design)motorcycle.
• Intheory,itappearsthattheISTIgnitionwithitsnoseconemountedpick-upshouldbeadaptabletoanyHarleyDavidson®bigtwinmotorbuiltsince
10
Picture 14
Picture 15
Table 1
Wire Color Coil Terminal
Designation
Main Stripe