Manual

3
4- Using Permatex® Right Stu® gasket maker apply to the four points as shown (both sides of the gasket) and install the gasket, install the cover
and screws. Use an all to help align and hold the gasket and cover in place.
5- Swing the line into place and tighten to tting.
6- Repeat for each line & cover assembly
7- Tighten rocker shaft nuts, and rocker housing bolts.
NOTE: To ensure the best overall seal, it is best to have the rocker housing bolts loose as well as loosening the rocker arm shaft nuts. The housing will pull
the cover tins into the rocker arm seal as you tighten the rocker shaft nuts.
Picture 5
Picture 6
Picture 7
1
2
3
4