User guide



CAUTION

Knock sensor must be mounted to the rear cylinder or rear top motor mount. Mounting the knock sensor on the front cylinder will

provide an incorrect signal.

 











 



 

 



 

Position the mounting block so that the knock sensor or mounting block do not interfere with the gas tank or any other part of the

motorcycle. If the knock sensor wiring or the outer body of the knock sensor contacts the engine or any other part of the motorcycle, it

could damage the knock sensor, or interfere with its ability to detect knock.

CAUTION

 



 

Hold the knock sensor in position by hand while torquing. Do NOT use pliers or damage to the knock sensor will occur.

 



Picture 2