Owner manual

9
 
NoteS:
Before installing the intermediate cam cover, apply a coating of high-temp wheel bearing grease to the inside of the pinion seal. 
Position all four cam lobes toward the center of the intermediate plate before installing on to the crankcase to aid in clearing the rollers on the tappets. 
 
Note: The tensioner is a non-service item and should be replaced as a unit.
 
PINION SPROCKET INSTALL
 
Note: It is possible to install this 180° o. Be sure the dot matches the mark on the sprocket and front piston is at TDC.
 

 
 
 
Picture 20
Picture 21