Owner's manual

9- Install wire clip on center case bolt and torque to 8 ft-lbs as shown in Picture 13. Route the wires along the back side of the
pushrods, through the clip (Pictur
e 14) and then along the frame. Be sure they do not contact any hot or moving parts.
10- Mount the VOES switch as close to the carburetor as possible using the included bracket. Note: There is no polarity
on the VOES so either wire can be used for ground or signal.
11- Connect the VOES hose from the switch to the nipple in the manifold. Trim the hose to be as short as possible
without stretching or kinking it.
NOTE: The Super Stock
®
ignition is a single-fire design requiring a single fire coil with a minimum of 3.0 ohms resistance. Dual-plug
engines will require two coils or a four-tower coil.
6
Picture 13
Picture 14
Picture 15