Owner's manual

NOTE: If you are not using S&S
®
Super Stock
®
Ignition, follow the manufactures instructions now.
6- Install the timing cup on the driveshaft with the alignment tab in the indexed position. Use the included brass screw with
threadlock on it and tighten to 15-20 in-lbs.
7
- Wrap the end of the wire sheathing with a small piece of electrical tape to make it easier to pass them through the rubber
grommet in the timing cup.
8- Place wires through the grommet and install the Super Stock Ignition oriented with the S&S logo oriented towards the cylinder.
Install the ignition standoffs hand tight.
Picture 10
Picture 11
Picture 12
5