Instruction Manual

4
III. Make electrical connections according to following chart and wiring diagram.
Ignition Module
White/Black Switched 12-volt power Small ring terminal
Pink Front cylinder on coil Small ring terminal
Blue Rear cylinder on coil Small ring terminal
Violet/White VOES Tab assembly (male)
Brown Tachometer/Diagnostic Port Tab assembly (male)
VOES Switch
Black Ground Large ring terminal
Black Ignition module Receptacle assembly (female)
3- Install Oil Lines
A- First, ush the oil tank and lines and install a new oil lter that has been lled with oil.
CAUTION
New oil tanks and lines must be ushed to remove any debris that could damage the engines oiling system.
B- Connect oil lines following the diagram on the following page. Do not connect the oil feed line to the engine at this time.