Owner manual

7
Cam Belt Drive Replacement
Be sure the battery is disconnected to prevent any accidental engine turnover during the service.

 
 
 

 

 
NOTE: An ⁄" open-end wrench may be used in place of S&S socket tool, PN 106-0750.
Do not bend the belt tighter than the size of the pulleys. Do not twist the belt or crease it.

 
 
 
 
 
 
 
 
 
NOTEs:
⁄” by 2” long dowel pins may be used in place of S&S® cam Alignment Pins PN 106-0576. 
If you do not have S&S Cam Alignment Pins or ⁄” dowel pins, the belt is marked with alignment points on its edge. Align the hole in the cam sprockets 
with the alignment holes in the cam plate, align the crank pulley with FTDC, and align the belt marks with the dot on the edge of the sprockets.
Engine Specications
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
WARNING
WARNING