Instruction Manual

ManualsBrandsS&S Cycle ManualsFor motorcycles2006-Up Gear Drive Cams for Harley-Davidson Twin Cam 88 Engines

 See Picture 10.

Picture 10

NOTE: The support plate assembly should slide into place without resistance. If resistance is encountered, determine the cause and correct the problem

before proceeding. Do not force the support plate into position. The camshafts must be installed into the cam support plate before installation. Failure to

due so could result in damage to the cam support plate and bearing surface.

 See Picture 9.

CAUTION

Support plate screws that pass through alignment dowels can be easily stripped (See positions 1 & 2, in Figure 2) when applying maximum

120 in-lbs torque as recommended by Harley-Davidson®.

 

See Figure 2.

  Figure 1 





 











NOTE: Crankshaft and Outer cam drive gears have a light press t on their respective shafts. Start gears squarely on their shafts and use their mounting

bolts to pull them all the way into position.

 





 

