User Guide

CONNECT ELECTRICAL WIRING
INSTALL GRILLE
WIRE
PANEL
UNIT
BLACK (BLK)
SWITCH BOX
FAN
SWITCH
POWER SUPPLY
120V AC
GROUND (GRD)
WHITE (WHT)
FAN
RECEPTACLE
FAN
Install ceiling material to complete the ceiling construction and cut around
the fan housing.
To attach the grille assembly to the fan housing, pinch the grille springs on
the sides of the grille assembly and position the grille into the housing with
the grille springs in the appropriate slots. Push the grille assembly towards
the ceiling to secure.
Screw
OPTION FUNCTION
Run 120 V AC house wiring to the location of the fan. Use only UL-approved connectors (not included) to attach the house wiring to the
wiring plate. Refer to the wiring diagram, and connect the wires as shown.
3
If adding a Plug and Play Module (PCHSP – Humidity Sensor/ PCSCP –
Speed Control/ PCMHKP – Motion/Humidity Sensor, etc.), align the
module as shown in the diagram to the right. Secure the module to the
housing with the screw and connect the plug to the corresponding plug on
the wire panel at the opposite corner of the fan housing (replace the
standard fan grille with a motion sensing/lighted grille and make the
additional plug connections as necessary). Refer to the individual module
accessory IOMs for more details and wiring instructions