User's Manual

ON / STANDBY
Tuning
1 Press the ON/STANDBY button to turn the power on.
2 Press the TUNER [BAND] button (remote control) or
FUNCTION button (main unit) repeatedly to select FM
Stereo, FM Mono or AM.
3 Manual tuning:
Press the TUNING (
or ) button repeat-
edly to tune in to the desired station.
Auto tuning:
Press and hold the TUNING ( or ) button.
Scanning will start automatically and the tuner will stop at
Notes:
When radio interference occurs, auto scan tuning may
stop automatically at that point.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING
(
or ) button again.
To receive an FM stereo transmission:
Press the TUNER [BAND] button to select stereo
mode. “ST” indicator will be displayed. “
” and “ ” will
appear when an FM broadcast is in stereo.
If the FM reception is weak, press the TUNER [BAND]
button to extinguish the “ST” indicator. The reception
changes to monaural, and the sound becomes clear
-
er.
Memorizing a station
You can store 40 FM and AM stations in memory and re-
call them at the push of a button. (Preset tuning)
1 Perform steps 2 - 3 in “Tuning”.
2 Press the MEMORY button.
3 Within 30 seconds, press the PRESET ( or ) button
to select the preset channel number. Store the stations
in memory, in order, starting with preset channel 1.
4 Within 30 seconds, press the MEMORY button to store
that station in memory. If the “MEM” and preset num-
ber indicators disappear before the station is memori-
zed, repeat the operation from step 2.
5 Repeat steps 1 - 4 to set other stations, or to change a
preset station. When a new station is stored in the me-
mory, the station previously memorized for that preset
channel number will be erased.
Note:
The backup function protects the memorized stations for a
few hours should there be a power failure or the AC power
cord become disconnected.
To recall a memorized station
Press the PRESET ( or ) button to select the desired
station.
To scan the preset stations
1 Press and hold the PRESET ( or ) button until the
be tuned in sequentially, for 5 seconds each.
2 Press the PRESET ( or ) button again when the
desired station is located.
To erase entire preset memory
1 Press the ON/STANDBY button to turn the power on.
2 Press the FUNCTION button (main unit) repeatedly
or TUNER [BAND] button (remote control) to select
Tuner function.
3 In Tuner function, press and hold the CLEAR button
(remote control) until “Tuner Clear” appears.
Listening to the radio
E-16