User's Manual

E-18
■ Open Accessory
Symptom Possible cause
● No sound is
produced.
● The device is not pla\ing.
● The device is not properl\
connected to the unit.
● The A& power cord of the
unit is not plugged in.
● 'evice will not
charge.
● The device is not PaNing
full contact with the US%
terPinal.
■ CD player
Symptom Possible cause
● 3la\EacN does not
start.
● 3la\EacN stops in
the Piddle or is not
perforPed properl\.
● The disc is loaded upside
down.
● The disc does not satisf\
the standards.
● The disc is distorted or
scratched.
● 3la\EacN sounds are
sNipped or stopped in
the Piddle of a tracN.
● The unit is located near
excessive viErations.
● 9er\ dirt\ disc has Eeen
used.
● &ondensation has forPed
inside the unit.
■ USB
Symptom Possible cause
● 'evice cannot Ee
detected.
● Is there an\ M3WMA ¿le
availaEle"
● Is the device properl\
connected"
● Is it an MT3 device"
● 'oes the device contain
AA& ¿le onl\"
● 3la\EacN does not
start.
● Is it a cop\right protected
WMA ¿le"
● Is it a false M3 ¿le"
● Wrong tiPe displa\.
● Wrong ¿le naPe
displa\.
● Is 9ariaEle %itrate ¿le
Eeing pla
\ed EacN"
● Is the File NaPe written
in &hinese or -apanese
characters"
■ Tuner
Symptom Possible cause
● The radio PaNes
unusual noises
continuousl\.
● The unit placed near a T9
or coPputer.
● The FM antenna is not
placed properl\. Move the
antenna awa\ froP the A&
power cord if it is located
nearE\.
■ Condensation
Sudden tePperature changes storage or operation in an
extrePel\ huPid environPent Pa\ cause condensation
inside the caEinet &' picNup etc. or on the transPitter
on the rePote control. &ondensation can cause the unit to
Palfunction. If this happens leave the power on with no
disc in the unit until norPal pla\EacN is possiEle aEout 1
hour. Wipe off an\ condensation on the transPitter with a
soft cloth Eefore operating the unit.
■ If problem occurs
When this product is suEMect to strong external interfer-
ence Pechanical shocN excessive static electricit\ aE-
norPal suppl\ voltage due to lightning etc. or if it is oper-
ated incorrectl\ it Pa\ Palfunction.
If such a problem occurs, do the following:
1 Set the unit to the standE\ Pode and turn the power
on again.
2 If the unit is not restored in the previous operation unplug
and plug in the unit again and then turn the power on.
Note:
If neither operation aEove restores the unit clear all the
PePor\ E\ resetting it.
Troubleshooting chart (continued)